My bronco recently started to have a problem when i start it the started stays ingauged. I replaced the ignition swith and still has the same problem. Anyone have any ideas or a wiring diagram?
Thanks
78 Bronco Problem
Started by
bousy1
, Mar 02 2004 11:26 AM
3 replies to this topic
#2
STLKIKN
-
- Members
-
- 103 posts
F-Series Maniac
- Location:Calgary Alberta
- Interests:EBs, EBs, Boobies... you know, all the important things in life!
Posted 02 March 2004 - 05:25 PM
Sticking starter relay
Bad ring gear teeth
Bad starter drive gear
Broken plunger return spring
Sticking plunger
Wrong starter for your application ( too short or too long rear housing)
Start with the relay (solenoid)
disconnect the starter power at the relay.
Put the key to start...
Use a voltmeter or test light to check for voltage after releasing the key to the run position.
If the relay is ok, you will have to remove the starter and start inspecting pieces.
Good luck.
Bad ring gear teeth
Bad starter drive gear
Broken plunger return spring
Sticking plunger
Wrong starter for your application ( too short or too long rear housing)
Start with the relay (solenoid)
disconnect the starter power at the relay.
Put the key to start...
Use a voltmeter or test light to check for voltage after releasing the key to the run position.
If the relay is ok, you will have to remove the starter and start inspecting pieces.
Good luck.
Reply to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
