Now, I have an 1988 F250 that has me over several hurdles and lots of cash only to end up here:
Replaced the motor, front and rear axle D60F W/ 10.25 full foater) vs D44 IFS. transfer case.
In the last week I have replaced the exhaust manifolds with Pacesetter tube header and finally attacking the rust. Have made great progress only to find the CAB mounts are shot. I bought a new set of Prothane urethane ones sold as a kit only to find there isn't a kit (no bolts, washer or anything else just the rubbers).
so, I need new conical washer contraptions. I called my local dealer and they want 78.00 each for 1 piece. Part #B4TZ1000157C This was the number he gave me.
I'd hate to have to make a set of washers since all of them seem a little different and the is a top and bottom portion. Plus I don't have anything to go by. And would just be guessing as to design.
Anybody have any ideas or know where I might be able to find these? Or even some pictures with measurements or just measurements for that matter.
Thanks Jennifer
Edited by Suchislife, 21 August 2009 - 09:49 AM.
