I have replaced this sucker two times and the light still comes on. It stays off until I hit 40 mph exactly then stays on until I shut my truck off. Once I restart I believe the system resets and the light won't come on again until I hit 40 mph again. Any thoughts???? Thanks
Rabs Sensor 1990 Bronco
Started by
Guest_pooh145_*
, Mar 25 2004 02:18 PM
2 replies to this topic
#2
Billz4x4z
-
- Members
-
- 107 posts
F-Series Maniac
- Location:Carnesville,GA
- Interests:Trucks,4 Wheelin,Workin on Stuff,campin,the outdoors,NASCAR,meetin new people to go wheelin with,Truck shows family time
Posted 25 March 2004 - 03:05 PM
Beacause of where there located the build up with crud,I would check for broken wires,at or before the sensor.If not have it put on a diagnostic machine,that will help pinpoint the problem.
You may have a problem,in the ABS system itself,ie the controller right below the master cylindrer.
Bill
You may have a problem,in the ABS system itself,ie the controller right below the master cylindrer.
Bill
If ya don't get hung up once in a while your not wheelin hard enough
#3
Guest_Deep_*
Guest_Deep_*
-
- Guest
Posted 25 March 2004 - 08:19 PM
You will find a sensor on the differential, and that particular sensor will cause the problem you are describing. I was have the same issue with my 87. The good news is that its a cheap part, it sells for around $15.00 - $20.00. I purchased my at autozone. You can go online with autozone and check the price and availability in your area. The other good news is that the sensor is located at the top (12:00) of the rear end housing and is easy to access. It is held in place with a sinlge bolt. Clean the area around the sensor real good so as not to run a risk of getting crap into ya gears.......hope this helps ya out.
Reply to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
