I bought the stainless steel hard line brake kit from Jeff's Bronco Graveyard, along with braided s.s. lines for the left front, right front, front main, and rear main.
The problem is, I have 4-5 connections leaking like crazy. In fact, after letting the truck sit for a while, my brake fluid has leaked out and I have no pedal. Annoying.
I've worked on brakes quite a bit in my time, and I usually tighten brake connections moderately tight. When it starts to twist the hard line, then I typically stop there. At that point, these kept leaking. So I continued to tighten them until I felt they simply couldn't go any tighter, and they still leak.
Any suggestions out there? Anyone have this same problem?
Thanks,
John
'78 Bronco Brake Line Leaks
Started by
Guest_Enduroguy_*
, Apr 13 2004 12:35 PM
3 replies to this topic
#2
Billz4x4z
-
- Members
-
- 107 posts
F-Series Maniac
- Location:Carnesville,GA
- Interests:Trucks,4 Wheelin,Workin on Stuff,campin,the outdoors,NASCAR,meetin new people to go wheelin with,Truck shows family time
Posted 13 April 2004 - 02:35 PM
Take them apart and make sure there is no defects in the fittings or the flares.Stainless is a harder material than regular steel,and sometimes the flares weren't finished properly.
All else fails call the place where ya got em,and tell them your problem.
Just my thoughts.
Bill
All else fails call the place where ya got em,and tell them your problem.
Just my thoughts.
Bill
If ya don't get hung up once in a while your not wheelin hard enough
#3
Guest_Guest_*
Guest_Guest_*
-
- Guest
Posted 20 April 2004 - 06:11 AM
you should try to pull directly back on the line while tightening the fitting, this will help it seat correctlyI bought the stainless steel hard line brake kit from Jeff's Bronco Graveyard, along with braided s.s. lines for the left front, right front, front main, and rear main.
The problem is, I have 4-5 connections leaking like crazy. In fact, after letting the truck sit for a while, my brake fluid has leaked out and I have no pedal. Annoying.
I've worked on brakes quite a bit in my time, and I usually tighten brake connections moderately tight. When it starts to twist the hard line, then I typically stop there. At that point, these kept leaking. So I continued to tighten them until I felt they simply couldn't go any tighter, and they still leak.
Any suggestions out there? Anyone have this same problem?
Thanks,
John
Reply to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
