Jump to content


Photo

stuck distributor

distributor

1 reply to this topic

#1 Hal

Hal

    F-Series Newbie

  • Members
  • 1 posts
  • Favorite F-Series Year?:1988

Posted 19 July 2015 - 10:00 AM

trying to unstick a 460 distributor. trying to adjust timing. loosened hold down bolt but distributor will not budge. any ideas. tried liquid wrench. nothing.



#2 miesk5

miesk5

    F-Series Maniac

  • Moderators
  • PipPipPipPipPip
  • 145 posts
  • Gender:Male
  • Interests:Broncos, beach runs, surf fishing
  • Favorite F-Series Year?:1996

Posted 21 July 2015 - 06:10 AM

yo HAL,
WELCOME!
I usually use a scratch awl and remove as much corrosion between the distributor and the block as I can, then use a huge adjustable wrench to turn it after dousing it with Kroil.



I used some pb blaster and a little knocking from my hammer and it budged.

Mix a small bottle of 50/50 ATF and acetone (nail polish remover is made of acetone)


taped it around with the BFH pretty hard, but I was planning to replace it anyway


Some tips from other 78/79 Bronco owners;
Didn't want to use a torch for fear of damaging plastic parts. Used oil and a 12" pipe wrench (instead of water pump pliers, because it grips/bites harder when turned) a cheater pipe and lots of gentle tapping with a BFH. Didn't make the dizzy housing shaft any prettier, but it came out and sandpaper smoothed most of the marks.
96 Bronco, E4OD, Man Xfer Case & Hubs
See my Big Bronco & F Series Technical & Parts LINKS site. Will need to clean up dead links & add many more new links some day. Thanks to Mr. Schwim! http://schwimserver5.com/?index=1128
Thanks to All Who Serve



Reply to this topic



  


1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users